ZAP CA (Pink Label) Thin Viscosity 

Super-thin penetrating formula. Works great on most materials, especially Plastic, Carbon Fiber, Balsa and other soft woods. Excellent "wicking" action, gets in to places medium and thick CA just wont go. Strengthens fiberglass cloth for patching Helicopter canopies. Bonds in 1 to 5 seconds. Also great for cracks in Carbon fiber frames, landing gear, and fins, this will soak right in to the carbon cracks and bond in seconds..

• SUPERIOR PENETRATING FORMULA
• THIN - WATER/RUBBING ALCOHOL LIKE CONSISTENCY
• BONDS AND CURES IN 1 TO 5 SECONDS
• WORKS ON MOST MATERIALS

Uses:
ZAP CA Is the thinnest CA in the ZAP product line. The penetrating or wicking ability of this glue makes it a favorite of modelers around the world. Balsa wood is bonded almost instantaneously, with the glue sometimes traveling several inches into the parts. The consistent performance and strength of the glue is what sets it apart from other brands. This product is also widely used throughout the hobby industry; the thin formula allows the glue to go where most cannot. Wood turners like the penetrating ability for hardening soft areas and preventing the propagation of cracks. Furniture refinishers can count on ZAP CA to wick under loose veneer without having to remove the piece and chance damage. Mold and pattern shops coat the outside of the wood pattern, hardening it for final finishing. Cracks almost disappear in ceramic and hardened plaster pieces. Use it on fiberglass and cloth to bond, reinforce, and strengthen wood parts and assemblies. Plastic parts can be joined with an almost invisible seam.

Helpful Hints:
It travels fast and sets up fast. It will bond skin instantly. Because of this glues geat wicking ability it will travel along an edge or seam for several inches. It will penetrate deep in to a crack just by applying the glue at one end. When bonding balsa wood, hold the parts together and apply a small amount of glue at the seam where the parts meet. The glue will penetrate the joint and wick into the balsa parts. Don’t hold the balsa to close to the joint or you will find that you are glued to your parts. For porous products you may have to apply more glue to get the strongest bond, it would be best to try bonding some test pieces to determine the proper amount. When sealing and hardening wood parts use in a well ventilated area and work on small sections. Do not use kicker with this glue, in most cases the glue will have set before you can apply the accelerator. For critical applications test sample joints for designed strength requirements.