Special Wide 3M Double Sided FBL Tape 10 feet (Specifically for FBL Systems)

• Pilots want the best tape for there FBL units, and it doesn't get better than 3M brand tape!

• Width x Length = 3 meters long x 30mm wide (about 10 feet long x 1.2 inches wide)
• Use for: for IKON2, Brain2, Microbeast, V-Bar, or almost any other FBL on the market.
• More details below photo.

  Here at Anythingheli.com we have tested dozens & dozens of tapes from 3M for over a decade, and this exact version of 3M tape works better than we ever expected, and was easily the winner among all that we tested.

  Anythingheli.com tests were done on everything from the OMP M1 / M1 EVO and M2 / M2 EVO, GAUI X5 and X7, Raw 420, Goblin 500, Goblin 570, RAW 580, Goblin 630 , RAW 700, and 770, mostly (except the OMP's) using MSH brain, Microbeast, and V-Bar!

Pilots Note: We gave samples to all our Team pilots, & most of our local pilots, they tried the tape on their V-bars, MSH brain, IKON, Microbeast, all OMP M1 and M2 versions. And when we asked our test pilots, and local pilots about this tape after they had time to use it for a few months, they all responded with positive comments, just about every one of them said they like this stuff better than what comes stock with their FBL units, a couple local pilots said they did not see a change, but this was definitely a better deal getting 10 feet instead of a few inches for 7 to 10 bucks from the FBL manufacturers!

One roll will last you a long, long, long time since this is a 10 foot roll! It's a huge value when compared to buying small little replacement pieces from the FBL manufacturers.

Side Note: Works great for OMP M2 batteries as well, it's what we use here at Anythingheli to mount the OMP battery to the stock trays, and the plastic ION RC trays. This particular tape has a special sticky backing that will not let go, and will hold your OMP battery to your tray with no need for cumbersome velcro straps!

Instructions: Clean both mating surfaces well with IPA (90% or higher is best) before you use the tape. A clean surface is key to proper tape adhesion.  Once you have your FBL, Satellite, ESC, battery, or whatever else you may want held down, apply pressure for 30 to 60 seconds, then let sit @ room temp for 24 hrs to let the special adhesive on the tape set up properly. Then your good to go!

You can opt to use the tape right after you stick your item down, but full adhesion is at 24 hours, even if it seems like the tape is holding really good immediately, it's not 100% until after 24hrs, then it's stuck!