Scorpion HK-4035 V2 / HKIII-4035 Motor Shaft Kit, 6mm shaft (30mm)

• This is the new version shaft made from a new, much stronger SKH51 Steel alloy that will hold up to the most extreme 3D flying.
• Total length of this shaft is 94.7mm,, 30mm of that is 6mm pinion shaft.
  
• This is a OEM Scorpion replacement for all HKIII-4035, HK-4035, HKII-4035 Motors
  

 
This is the new version shaft made from a new, much stronger SKH51 Steel alloy that will hold up to the most extreme flying styles. If you are looking to get the hardest and strongest shaft available, this is the one. This material is much more expensive than the earlier material used, and is why these shafts are significantly more pricey.

The Scorpion HK-4035 motors are built with hardened steel that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, we offer factory replacement shafts for all the HK-4035 series Scorpion Helicopter Motors. Our Motor Shaft Kits include an original equipment factory shaft, a new spacer washer, and a set of "2" retaining clips. This way, when one goes flying and bounces off the wall while you are trying to install it, never to be found again, you still have another one to use!

 Please measure your helicopter to be sure that 30mm of 6mm pinion shaft area is correct for you. 

Included in the Package:

• - Scorpion OEM HK4035 Motor Shaft (for 6mm pinion) OEM x1
• - Washer x 1
• - C-Clip x 2
• - Set Screw x 2

Note: the shafts in the Scorpion motors are a slight press fit into the aluminum front housing. The shafts will not just slide out when the setscrews are removed. They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing.