Customer Reviews

There are currently no product reviews.

 Castle Creations BEC-PRO "High Output" Voltage Regulator 20A

The BEC Pro "High Output" Switching Battery Eliminator Circuit is sporting a new case design for better cooling capabilities, along with new internal design for better voltage regulation.

 (Very Latest Version)

The above Diagram is for single battery set-ups, look below for 2-battery set-ups (eg. 8S/10S/12S/14S/16S)"

Anythingheli.com PRO Note: For 8S/10S/12S/14S/16S helicopter set-ups, the picture below shows the best, safest, most efficient way to wire the BEC when running 2 packs in series. Notice the BEC is using power from ONLY 1 battery pack in a 2 battery (series) set up. This is by far the best way when connecting to a 8, 10, 12, or 14 cell set up that uses 2 batteries in series, it will allow for higher continuous amperage output by the BEC. This also allows for powering the RX electronics, without powering the esc/motor when working on the bench by plugging in only pack 1. Also note that the BEC and The ESC share a common (same) ground wire as shown in photo below, this is very important!